[TriEmbed] PCBs with 3.5 pin pitch

[The MacDougals]

Something like this takes just a few minutes to design in Eagle and send to
OSH Park for your own custom boards.

It will likely run you under $5 to make three boards.

I just did a board with four of these 3 pin screw terminals with 3.5mm
spacing.

 

---> Paul

 

 

From: TriEmbed [mailto:triembed-bounces at triembed.org] On Behalf Of Rodney
Radford
Sent: Tuesday, December 10, 2013 12:30 PM
To: Grawburg
Cc: Triangle Embedded Devices
Subject: Re: [TriEmbed] PCBs with 3.5 pin pitch

 

If you just want a common bus across all of the terminals, why not just use
a piece of copper PCB, drill out the holes and solder it in place?

 

On Tue, Dec 10, 2013 at 11:46 AM, Grawburg <grawburg at myglnc.com> wrote:

I purchased a bunch of screw terminals (2 & 3 position) to mount on a PCB,
but did not realize they
were 3.5mm pitch.  I'm getting tired of trying to find some small boards
that I can attach them to.
Any suggestions of where to look?  I'm simply going to use 2 or 3 each on a
strip to make a common
connection point, i.e. sort of a header strip to distribute 12 VDC so I need
a common soldering strip.


Thanks,
Brian Grawburg



--
The truth will set you free . . .but first it will infuriate you.





_______________________________________________
Triangle, NC Embedded Computing mailing list
TriEmbed at triembed.org
http://mail.triembed.org/mailman/listinfo/triembed_triembed.org
TriEmbed web site: http://TriEmbed.org

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.triembed.org/pipermail/triembed_triembed.org/attachments/20131210/b595f4e8/attachment.htm>