[TriEmbed] PCBs with 3.5 pin pitch

[Scott Hall]

Or just use a piece of strip-board, though the holes won't be 0.147" apart.

On 12/10/2013 12:29 PM, Rodney Radford wrote:
> If you just want a common bus across all of the terminals, why not just use a
> piece of copper PCB, drill out the holes and solder it in place?
>
>
> On Tue, Dec 10, 2013 at 11:46 AM, Grawburg <grawburg at myglnc.com
> <mailto:grawburg at myglnc.com>> wrote:
>
>     I purchased a bunch of screw terminals (2 & 3 position) to mount on a PCB,
>     but did not realize they
>     were 3.5mm pitch.  I'm getting tired of trying to find some small boards
>     that I can attach them to.
>     Any suggestions of where to look?  I'm simply going to use 2 or 3 each on
>     a strip to make a common
>     connection point, i.e. sort of a header strip to distribute 12 VDC so I
>     need a common soldering strip.
>
>

-- 
Scott G. Hall
Raleigh, NC, USA
ScottGHall1 at GMail.Com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.triembed.org/pipermail/triembed_triembed.org/attachments/20131211/0c88d8bc/attachment.htm>