[TriEmbed] Power FETs Vol 25, Issue 27

[Grawburg]

Well, I'm not sure what I did wrong originally, but I just tried a 3.3k that I had on the table...it worked just fine.
I also checked my resistor supply and I had a 100k so I put it between G-S.
Now I have to rephotograph the breadboard! :-)



-----Original Message-----
From: "Shane Trent" <shanedtrent at gmail.com>

Brian,

I have often seen 100 ohm resistors shown for the gate. You might try something in that range. Again, I am a little surprised the 33k didn't work slowly. Is there a chance that there is a pull-down resistor already on the gate? Did you try tying the 33k resistor directly to the 3.3v rail? 





-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.triembed.org/pipermail/triembed_triembed.org/attachments/20150618/c10de368/attachment.htm>