<div dir="ltr"><div>Hi All!</div><div><br></div><div>I am working on a project for a client to compile a PCB vendor survey and I'd like some input from my fellow consumers of PC boards. If you get a chance, please give me feedback on the following:</div><div><br></div><div>What are the factors that most make you go back to a PCB mfr - and what ones are most important?</div><div><br></div><div>What are the factors that make you not want to use a PCB supplier again?</div><div><br></div><div>Of course, cost, making delivery on time are factors but what are the intangibles? <br></div><div>DFM assistance? Working from EDA files rather than just Gerbers/drill? DRC issues?</div><div><br></div><div>Answering me directly at <a href="mailto:c.j.lord@ieee.org">c.j.lord@ieee.org</a> would be fine - answers will be kept anonymous.<br></div><div><br></div><div>Thanks much! Looking forward to joining you on the 10th to talk about my VxWorks experience!</div><div><br></div><div>Charles<br></div><div><br>-- <br><div dir="ltr" class="gmail_signature" data-smartmail="gmail_signature"><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr"><div>Charles J. Lord, PE<br></div><div>President, Blue Ridge Advanced Design and Automation<br></div><div><span>Chair, IEEE WNC Section 2018-2019<br></span></div><div>Past Chair, IEEE NC Council</div><div></div><div>Chair, IEEE SoutheastCon Steering Committee</div>Co-Chair, IEEE SoutheastCon 2020</div><div dir="ltr"><a href="mailto:c.j.lord@ieee.org" target="_blank">c.j.lord@ieee.org</a><br></div></div></div></div></div></div></div></div></div></div></div></div></div></div></div></div>