<div dir="ltr"><div><div><div><div><div><div>For years I have been reading about, researching, and wishing for a fancy Christmas light show on my house and I have decided next year I will put together my first setup.<br><br></div>My plan is to build several 8 and 16 channel light control boxes that have power in to the outlets, and be controlled from an esp8266 (arduino + wifi) controller fed to a 8x or 16x channel relay board. This would mean I only need to run one power line to each board and all control sequences can be controlled from one system inside the house.<br><br></div>I plan to put one on each side of the house for the bushes/trees and porch railing, and one on a large cone christmas tree (16x strands of 100 lights each).<br><br></div>I already have 165' of neopixels that I bought for this project about 2 years ago and I want to put them along the roof line.<br><br></div>I am researching different open source control software and have several that look promising, but have not downloaded and tried out yet.<br><br></div>I am reaching out to see if anyone else on the TriLUG and TriEmbed lists already have their own lights and if so, would you be willing to trade a few emails on ideas, suggestions, things to stay away from, etc?<br><br></div>Btw, this is the first video of a long series showing how to build the control boxes and using Vixen software to control the lights. I like the general idea, but I plan to use the esp8266 for the control link instead of a Raspberry Pi and wired ethernet. <br><br><a href="https://www.youtube.com/watch?v=WvG9c84ApFA">https://www.youtube.com/watch?v=WvG9c84ApFA</a><br><br>I have 11 months until Thanksgiving... that is my deadline.  <br><br>;-)<br><br></div>