<div dir="ltr">I am down to 23 days before I leave for SoutheastCon in Charlotte, and while most of the big items are done, or nearing completion, I have a lot of small tasks that need to be done.<div><br></div><div>I have two tasks I think I can farm out:</div><div>* soldering leader wires to the vibration sensor and neopixel sticks</div><div>* wiring up the relay boards</div><div><br></div><div>The first task just needs someone handy with a soldering iron. There are 8x neopixel sticks that need 3x wires soldered to each, and 8x vibration sensors that need 2x wires soldered to each. Once that is done, I will add the heatshrink around the connections and mount them to the light sabers. So a total of 40x solder joints to prep, solder, inspect - should take about 1-2 hours, tops.  If you are handy with a soldering iron and want to do this, let me know.  I will have the parts for this at tonight's TAR/IEEE meeting and can hand them off then - and can either meet you in the triangle to pick them up, or get them at the TriEmbed meeting next Monday night.</div><div><br></div><div>The second task is wiring up the relay tree that is used to select the parts for stage one (cap, inductor, wire, diode, inductor). This will involve about 35-40 wires to strip and connect to the relay tree (16x relay board). I have one person who has expressed interest in this (Paul Bell), but since there are 9-9x of these relay boards to do, perhaps this job can be split among several people. The big issue is I have not completed the wiring diagram for this yet - a task on my TODO list or the next few days.  I can meet you in the triangle area to give you the boards, wires, and connection diagram if interested.</div><div><br></div><div>Thanx,</div><div>Rodney<br><br><br></div></div>