<div dir="ltr"><div class="gmail_quote">Jon,</div><div class="gmail_quote"><br></div><div class="gmail_quote">Thanks for the thoughts.  I get the distinct feeling that you pointed out the IP conflict for a good reason.  Are the clones are shipping without their own software or are some pirating Saleae's IP?</div><div class="gmail_quote"><br></div><div class="gmail_quote">Mike</div><div class="gmail_quote"><br></div><div class="gmail_quote">On Jun 28, 2016 9:48 PM, "Jon Wolfe" <<a href="mailto:jonjwolfe@anibit.com" target="_blank">jonjwolfe@anibit.com</a>> wrote:<br type="attribution"><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div>Get a one of the older saleas, or get a cheap copycat off ebay, and use it with Sigrock Pulseview. (You're not using any Saleae ip in this case, Sigrok uses it's own firmware).<div><br></div><div>You can record for a long, long time with that setup, though max speeds are limited to what can be streamed over usb in realtime. (Should be fast enough for your case)</div><div><br></div><br><br>-------- Original message --------<br>From: Michael Monaghan via TriEmbed <<a href="mailto:triembed@triembed.org" target="_blank">triembed@triembed.org</a>> <br>Date: 6/28/2016  9:18 PM  (GMT-05:00) <br>To: Triangle Embedded Computing Discussion <<a href="mailto:triembed@triembed.org" target="_blank">triembed@triembed.org</a>> <br>Subject: [TriEmbed] Logic Sniffer Recommendations <br><br><div dir="ltr"><div><div>Hi everyone,</div><div><br></div><div>I'm in the market for a logic analyzer.  Having just used a Saleae Logic 4, I know it'll do what I need.  I know there are clones and there are options like the Logic Pirate.  I need to record 30+ seconds of RS232 to look at the bit timing which is either 8.32 microseconds or 8.8 microseconds in previous tests.</div></div><div><br></div><div>Does anyone have any recommendations for a logic analyse that will allow me to record for up to a minute at 20MHz or higher?</div><div><br></div><div>Background... I'm diagnosing a device that runs Async at 115200, or at least is it supposed to.  I is actually running at 120192 because the virtual UART isn't initialized correctly.  That's 4.3% on a spec tolerance of 3.3% max.   As is always the case, the vendor had more questions after I submitted the test results, so I need to run more tests.</div><div><br></div><div>Thanks,</div><div><br></div><div>Mike</div></div>
</div></blockquote></div>
</div>