All, <div>Down to the final stretch on my new board - just need one more piece of advice. <span></span></div><div><br></div><div>I am trying to see if there is a way to accomplish something without resorting to a physical jumper. I would like to use the FTDI header on my new board in two ways with respect to the power pin. <br></div><div><div><br></div><div>1) when I connect a FTDI connector, it could power the board. The power pin is connected directly to the board's power rail. This is how it is today. </div><div><br></div><div>2) when I connect the Adafruit UART friend, I can turn it on and off using one of the Arduino's digital pins.  In this scenario, I only want the power pin connected to the digital pin on the Arduino. </div><div><br></div><div>Is there some way to automatically switch between these two modes based on whether there is power supplied by the FTDI adapter?</div><div><br></div><div>Thanks, </div><div><br></div><div>Chip</div><div><br></div><div><br></div></div><br><br>-- <br>Sent from my iPhone - please excuse the typos<br>