<div dir="ltr"><div><div><div><div><div><div><div>I have a Maximus VII Hero motherboard with an i7 4990k CPU that I put together as the brain basis for the new humanoid robot being built by the IEEE Robotics and Automation group.<br><br></div>I put everything together about a month ago and it has been working fine.  Today it booted up to the OS and then promptly shut down a few seconds later.  Every attempt since then has resulted in various BIOS POST codes.<br><br></div>Looking online I see that the most obvious cause for the POST codes I was seeing was possibly a bent CPU pen, so I pulled out the CPU and I can see an area where some pins on the MB are bent.  Crap (actually I used much stronger words than that).<br><br></div>Again, consulting the web (and youtube), there are videos of people fixing the pins with a decent magnifying glass, a small sewing pin, and patience.  Since the TriEmbed meeting is tonight, I am planning to bring the MB in tonight and see if we can use the large projection screen to see the bent pins and possibly repair them.<br><br></div>If anyone is interested in a challenge, and has a steady hand, I could really appreciate the help.  My eyes are shot - I certainly can't do it, even with a decent magnifying glass - but I am hoping the projection screen will help.<br><br></div>If not, I am out $200-300 for the MB, and possibly some for the CPU if it was damaged - so I am desperate.  This was also supposed to be in a demo next Saturday (June 25th) which is another reason I am freaking out.<br><br></div>So hoping someone can help... leaving the house now and see you about 7pm.<br><br></div>Thanx,<br><br></div>