<div dir="ltr">Brian,<div><br></div><div>1) I expect the length of wire to the gate would NOT be a limiting factor in your application. It might slow down the switching a little but it sounds like it would not be an issue. I would use a resistor (100 ohm or so) between the I/O pin and gate and add a large pull down resistor, 100k-1M ohm, between the gate and source to ensure capacitive coupling cannot start turning on the FET.</div><div><br></div><div>2) You are correct that speed is a big reason to use a gate driver chip. If you are happy with the speed and Rds that you are getting with your existing logic drive you would not gain much by adding a gate driver.</div><div><br></div><div>3) The MOSFET gate is actually insulated from the Source and Drain by a thin layer of oxide insulation (hence the Metal Oxide in MOSFET) that insulates the gate and connected pin. So until failure of the gate oxide (over-voltage to static discharge), you are rather safe connecting an I/O pin directly to a MOSFET gate. The minimum protect required is typically a small resistor between the I/O pin and gate to limit the pulse current to the gate (the resistor can also reduce the tenancy of the MOSFET to ring or oscillate during operation). I am not sure that you gain a layer of protection by adding an expander chip, other than shorting out the wire to the gate would overload the expander chip rather than the Pi. </div><div><br></div><div>Shane</div></div><div class="gmail_extra"><br><div class="gmail_quote">On Thu, Jun 18, 2015 at 9:11 AM, Grawburg <span dir="ltr"><<a href="mailto:grawburg@myglnc.com" target="_blank">grawburg@myglnc.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div dir="LTR" style="font-family:Times New Roman,Times,Serif;font-size:16px">Nice technical explanation that I will need to ruminate on, but I do understand it well enough to ask these questions:<br><br>1. If the length of wire between the Pi and the FET is much longer than a foot I'm guessing that using a driver is mandatory, especially with a FET like the one I'm using.<br>2. If fast response is not essential, since we're only talking about milliseconds, the driver may be unnecessary.<br>3. Suppose I use an  externally powered (5VDC) I/O port expander (MCP23008) between the Pi and the FET? I gain a second layer of protection between the Pi and the load and now supply the gate with 5V.  Once again, I'm making a presumption that lightning-fast response is not essential. I really do like using these I2C devices.<br><br>Brian<br><br></div>



</blockquote></div><br><br clear="all"><div><br></div>-- <br><div class="gmail_signature"><div dir="ltr"><span style="color:rgb(0,0,0);font-family:HelveticaNeue-Light,'Helvetica Neue Light','Helvetica Neue',Helvetica,Arial,'Lucida Grande',sans-serif;font-size:16px">A blog about some of my projects.  <a href="http://fettricks.blogspot.com/" target="_blank">http://fettricks.blogspot.com/</a></span><br></div></div>
</div>