<div dir="ltr">I'm building a 1mx2m LED Matrix display (from the LEDs purchased in the January group buy). I've got the frame fabricated and will install the LEDs and power systems this weekend... but the one thing that's still a bit up in the air is how I'm going to divide the pixels. By which I mean box off each pixel so that no only does the light from one not bleed into the other when diffused, but so that each round LED shows up as a perfect 40mm square pixel.<div><br></div><div>Currently my plan is to use this method: <a href="http://wyolum.com/paper-baffle-extension-with-inkscape/" target="_blank">http://wyolum.com/paper-baffle-extension-with-inkscape/</a></div><div><br></div><div>I know the creator of that extension well, who even has a laser cutter and has offered to cut them for me... but his can only handle a max dimension of about 18". While I could cut a bunch of smaller sections, I would really prefer to have the baffles be in the largest continuous size possible, so 1m would be preferred.</div><div><br></div><div>Does anyone either have a cutter that large or know of a place I could order these from (file included)?<br><br>Alternatively, I'm open to other suggestions. My major concern with this method, while cheap, is that they would not be particularly sturdy. My current plan for the diffuser is basically just some white cloth stretched over the whole frame like a stretched canvas. But, if the front of the display were to get bumped during transport or something, it would literally crush the baffles.</div><div><br></div><div>Any thoughts appreciated :)</div><div><br></div><div>Adam</div></div>