<div dir="ltr">Paul,<div><br></div><div>I was drafting this e-mail when I realized that in my last post I misattributed your comments about calibration of the ATtiny resonators for SoftwareSerial. That procedure and your tips about use of multiple pin change interrupts on the ATtiny were great information. I apologize for the mistake.</div>
<div><br></div><div>I have looked for a relevant link on the resonator calibration procedure that you outlined but have had little luck. Could you point me in the right direction for learning more about the calibration? Do you recall the max baud rate that you could use reliably after calibration?</div>
<div><br></div><div>Thank you for your help.</div><div><br></div><div>Shane</div></div>