[TriEmbed] PCB Design Software Question

[Dwight Morgan]

Thanks Carl. I downloaded Eagle and will bear down on learning it. I’ve used AutoCad before so I’m hoping there is a wee bit of familiarity. There should be some good tutorials for it. 

Dwight 

Sent from my iPhone

> On Mar 25, 2019, at 10:45 PM, Carl Nobile <carl.nobile at gmail.com> wrote:
> 
> So Fritzing is the easiest and KiCad the hardest, the one in the middle is Eagle. Fritzing is so simple that it may not even be able to do what you want.  However, all these programs takes an investment of time to learn.
> 
> Carl
> 
>> On Mon, Mar 25, 2019, 10:22 PM Dwight Morgan via TriEmbed <triembed at triembed.org> wrote:
>> Hello All,
>> 
>>  
>> 
>> I’m trying to get a simple PCB off my bread board and on a PCB. I’ve been trying to use Fritzing and KiCad but it gets pretty harry and I’m thinking maybe there is a better software. What is a good solid program for a beginner with this effort to send files for fabrication? I know the group has probably covered this on some level before, but I wasn’t ready to take that on at the time. I think I can get it done with one of the programs, I just want a little advice.
>> 
>> Thanks for any input.
>> 
>>  
>> 
>> Dwight
>> 
>> _______________________________________________
>> Triangle, NC Embedded Computing mailing list
>> 
>> To post message: TriEmbed at triembed.org
>> List info: http://mail.triembed.org/mailman/listinfo/triembed_triembed.org
>> TriEmbed web site: http://TriEmbed.org
>> To unsubscribe, click link and send a blank message: mailto:unsubscribe-TriEmbed at bitser.net?subject=unsubscribe
>> 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.triembed.org/pipermail/triembed_triembed.org/attachments/20190325/49e8a153/attachment.htm>