[TriEmbed] Question: On/Off Sensor for Hot Water Heater

[Shane Trent]

Dwight,

Here is pre-built board that might do what you want. It's a good read about
using Hall Effect sensors for monitoring AC current.

http://moderndevice.com/new-products/current-sensor/

Shane

On Wed, Jan 14, 2015 at 2:15 PM, Dwight Morgan <dwight.w.morgan at gmail.com>
wrote:

> Hello All:
>
>
>
> I want to monitor when my hot water heater is on and off using my Arduino
> UNO. I have done research on sensors and it looks like the best choice is
> the ACS712 Hall Effect Current Sensor.
>
>
>
> My water heater has two 4500 Watt elements at 240 Volts. So the calculated
> current draw is 18.75 amps since only one element is on at a time.
>
> My question(s): First, is the Hall Effect sensor a good choice and second,
> if so, will the 20 amp rated one work okay?
>
>
>
> Also, if this is viable, I think I will try to use Cat5 cable to pick up
> the signal which will be about 100 feet away. I’m not sure exactly about
> the connectors yet.
>
>
>
> All advice is appreciated.
>
>
>
> Thanks!
>
>
>
> Dwight
>
>
>
>
>
> _______________________________________________
> Triangle, NC Embedded Computing mailing list
> TriEmbed at triembed.org
> http://mail.triembed.org/mailman/listinfo/triembed_triembed.org
> TriEmbed web site: http://TriEmbed.org
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.triembed.org/pipermail/triembed_triembed.org/attachments/20150114/015726ce/attachment.htm>